Academia.eduAcademia.edu

Figure 7 – uploaded by Igor Pašti

See full PDFdownloadDownload figure
Fig. 7. The stability and poisoning tests. Left: cyclic voltammograms of HAT-Carb-nanoPANI-modified GC electrode cycles at 50 mVs~! in the quiescent N2 (dashed line and O>-saturated (full line) 0.1 moldm~? KOH solution. Right: cyclic voltammograms of HAT-Carb-nanoPANI-modified GC electrode in N2 (dashed line) and O2-saturatec 0.1 mol dm-3 KOH solution (flat full line) and in O2-saturated 0.1 mol dm-? KOH solution upon addition of 0.1 mL 96% EtOH (full line through circles). Background curren! was recorded after the test, in the solution purged by No, catalyst loading in both cases was 250 pg cm.

Figure 7 The stability and poisoning tests. Left: cyclic voltammograms of HAT-Carb-nanoPANI-modified GC electrode cycles at 50 mVs~! in the quiescent N2 (dashed line and O>-saturated (full line) 0.1 moldm~? KOH solution. Right: cyclic voltammograms of HAT-Carb-nanoPANI-modified GC electrode in N2 (dashed line) and O2-saturatec 0.1 mol dm-3 KOH solution (flat full line) and in O2-saturated 0.1 mol dm-? KOH solution upon addition of 0.1 mL 96% EtOH (full line through circles). Background curren! was recorded after the test, in the solution purged by No, catalyst loading in both cases was 250 pg cm.

Related Figures (6)

Fig. 1. SEM image of HAT-Carb-nanoPANI.
Fig. 1. SEM image of HAT-Carb-nanoPANI.
Fig.2. Nitrogen adsorption-desorption isotherms of Carb-nanoPANI and HAT-Carb- nanoPANI. The inset shows the part of isotherms for the p/po range from 0.8 to 1.0. Total pore volume, Vict, specific surface area, Sper, cumulative mesopore volume Ves, cumulative micropore volume, Vic-HK and V;yic-DR, for Carb-nanoPANI and HAT-Carb- nanoPANI samples.
Fig.2. Nitrogen adsorption-desorption isotherms of Carb-nanoPANI and HAT-Carb- nanoPANI. The inset shows the part of isotherms for the p/po range from 0.8 to 1.0. Total pore volume, Vict, specific surface area, Sper, cumulative mesopore volume Ves, cumulative micropore volume, Vic-HK and V;yic-DR, for Carb-nanoPANI and HAT-Carb- nanoPANI samples.
Fig. 4. Raman (left) and FTIR (right) spectra of Carb-nanoPANI and HAT-Carb-nanoPANI. HAT-Carb-nanoPANI are presented in Fig. 2 in a comparative man- ner. The isotherms of both samples have virtually the same shape, typical for microporous materials and classified as type Ib isotherm, which passes at high relative pressure into a type II isotherm, characteristic for macroporous materials. The isotherms differ in the region of p/pp > 0.95 where HAT-Carb-nanoPANI shows higher slope than Carb-nanoPANI, reflecting the increase of the pore volume in the macropore region (pore diameter > 50 nm) upon the hydrothermal alkali treatment (Fig. 2, inset). The changes occurred also in both the mesopore region (2nm<pore diameter <50nm) and the micropore region (pore diameter <2 nm): the mesopore volume increased from ~0.22 to ~0.35 cm? g~!, and the micropore volume slightly decreased upon the applied hydrothermal alkali treatment (Table 1). Because of all mentioned changes, HAT-Carb- nanoPANI shows higher total pore volume V;o¢ than Carb-nanoPANI (Table 1). These porosity changes, however, were so balanced that The Raman spectra of HAT-Carb-nanoPANI and Carb-nanoPANI presented in Fig. 4, left, do not exhibit marked mutual differences. The both spectra are composed of two strong bands positioned at ~1590cm7! (G band, due to the stretching vibration of C-C bond in graphitic materials; common band to all sp? carbon systems) and ~1350cm ! (disorder-induced D band), respectively [32]. The peak intensity ratio Ip/I¢, determined using integrated peak areas, is found to be 3.477 and 3.399 for Carb-nanoPANI and HAT-Carb- nanoPANI, respectively. As the D band reflects the presence of disorder in sp2-hybridized carbon systems, obtained Ip/Ig values
Fig. 4. Raman (left) and FTIR (right) spectra of Carb-nanoPANI and HAT-Carb-nanoPANI. HAT-Carb-nanoPANI are presented in Fig. 2 in a comparative man- ner. The isotherms of both samples have virtually the same shape, typical for microporous materials and classified as type Ib isotherm, which passes at high relative pressure into a type II isotherm, characteristic for macroporous materials. The isotherms differ in the region of p/pp > 0.95 where HAT-Carb-nanoPANI shows higher slope than Carb-nanoPANI, reflecting the increase of the pore volume in the macropore region (pore diameter > 50 nm) upon the hydrothermal alkali treatment (Fig. 2, inset). The changes occurred also in both the mesopore region (2nm<pore diameter <50nm) and the micropore region (pore diameter <2 nm): the mesopore volume increased from ~0.22 to ~0.35 cm? g~!, and the micropore volume slightly decreased upon the applied hydrothermal alkali treatment (Table 1). Because of all mentioned changes, HAT-Carb- nanoPANI shows higher total pore volume V;o¢ than Carb-nanoPANI (Table 1). These porosity changes, however, were so balanced that The Raman spectra of HAT-Carb-nanoPANI and Carb-nanoPANI presented in Fig. 4, left, do not exhibit marked mutual differences. The both spectra are composed of two strong bands positioned at ~1590cm7! (G band, due to the stretching vibration of C-C bond in graphitic materials; common band to all sp? carbon systems) and ~1350cm ! (disorder-induced D band), respectively [32]. The peak intensity ratio Ip/I¢, determined using integrated peak areas, is found to be 3.477 and 3.399 for Carb-nanoPANI and HAT-Carb- nanoPANI, respectively. As the D band reflects the presence of disorder in sp2-hybridized carbon systems, obtained Ip/Ig values
Fig. 3. Cyclic voltammograms of carbonized PANI before and after hydrother- mal alkali treatment, in nitrogen purged 0.1 mol dm~? KOH solution; loading was 500 pgcm~?. Scan rate was 20 mVs"!.
Fig. 3. Cyclic voltammograms of carbonized PANI before and after hydrother- mal alkali treatment, in nitrogen purged 0.1 mol dm~? KOH solution; loading was 500 pgcm~?. Scan rate was 20 mVs"!.
Fig. 5. RDE voltammetric curves of HAT-Carb-nanoPANI-modified GC electrode recorded in oxygen saturated 0.1 mol dm-3 KOH with a scan rate 20 mV", left: at various rotation rates (rpm) at catalyst loading 250 yg cm; right: at unique rotation rate of 300 rpm, comparisons of RDE voltammograms of Carb-nanoPANI- (triangles) and HAT- Carb-nanoPANI-modified GC electrode (circles) both at two different catalyst loading 0.25 and 0.5 mg cm~?. For the sake of comparison, RDE voltammograms of polycrystalline Pt disk and N-doped vertically aligned NCNTs (VA-NCNT, 360 rpm [2]) are also included. Horizontal gray lines present limiting diffusion current densities of ORR, for 2e~ and for 4e~ O2 reduction route, respectively, calculated by means of Levich equation for 300 rpm.
Fig. 5. RDE voltammetric curves of HAT-Carb-nanoPANI-modified GC electrode recorded in oxygen saturated 0.1 mol dm-3 KOH with a scan rate 20 mV", left: at various rotation rates (rpm) at catalyst loading 250 yg cm; right: at unique rotation rate of 300 rpm, comparisons of RDE voltammograms of Carb-nanoPANI- (triangles) and HAT- Carb-nanoPANI-modified GC electrode (circles) both at two different catalyst loading 0.25 and 0.5 mg cm~?. For the sake of comparison, RDE voltammograms of polycrystalline Pt disk and N-doped vertically aligned NCNTs (VA-NCNT, 360 rpm [2]) are also included. Horizontal gray lines present limiting diffusion current densities of ORR, for 2e~ and for 4e~ O2 reduction route, respectively, calculated by means of Levich equation for 300 rpm.
In Fig. 5, the results of investigation of kinetics of ORR in oxygen saturated 0.1 mol dm~? KOH solution were presented. Although, as expected, the activity of studied material is found to be lower than the activity of polycrystalline Pt disk (Fig. 5, right), recorded RDE curves of HAT-Carb-nanoPANI-modified GC electrode (Fig. 5, left) indicate an excellent ORR electrocatalytic properties of the studied material. The most important result comes from the comparison of the electrocatalytic activity of Carb-nanoPANI before and after hydrothermal treatment (Fig. 5, right). If onset potential for ORR Fig. 6. Left: Koutecky-Levich plot for ORR on HAT-Carb-nanoPANI-modified GC electrode loaded to 250 and 500 pgcm~? in 0.1 moldm-3 KOH at various potentials a: indicated in the figure (left), theoretical Koutecky—Levich plots for 2e~ and 4e~ ORR routes are enclosed, too; Right: dependence of the number of consumed electrons pe O, molecule (n) on the electrode potential for synthesized Carb-nanoPANI (circles) and HAT-Carb-nanoPANI (squares) for two catalyst loadings. The RDE data were processed using Koutecky—Levich (K-L) anal- ysis [37]. It enables the determination of number of electrons consumed per O, molecule, giving an insight into the mechanism of ORR. Number of electrons (n) is determined from the slope of K-L lines defined by:
In Fig. 5, the results of investigation of kinetics of ORR in oxygen saturated 0.1 mol dm~? KOH solution were presented. Although, as expected, the activity of studied material is found to be lower than the activity of polycrystalline Pt disk (Fig. 5, right), recorded RDE curves of HAT-Carb-nanoPANI-modified GC electrode (Fig. 5, left) indicate an excellent ORR electrocatalytic properties of the studied material. The most important result comes from the comparison of the electrocatalytic activity of Carb-nanoPANI before and after hydrothermal treatment (Fig. 5, right). If onset potential for ORR Fig. 6. Left: Koutecky-Levich plot for ORR on HAT-Carb-nanoPANI-modified GC electrode loaded to 250 and 500 pgcm~? in 0.1 moldm-3 KOH at various potentials a: indicated in the figure (left), theoretical Koutecky—Levich plots for 2e~ and 4e~ ORR routes are enclosed, too; Right: dependence of the number of consumed electrons pe O, molecule (n) on the electrode potential for synthesized Carb-nanoPANI (circles) and HAT-Carb-nanoPANI (squares) for two catalyst loadings. The RDE data were processed using Koutecky—Levich (K-L) anal- ysis [37]. It enables the determination of number of electrons consumed per O, molecule, giving an insight into the mechanism of ORR. Number of electrons (n) is determined from the slope of K-L lines defined by:
Related topics:
EngineeringOxygen Reduction ReactionHydrothermal treatmentRotating Disc ElectrodeClinical Allergy and Immunology
580 California St., Suite 400
San Francisco, CA, 94104
© 2025 Academia. All rights reserved